You may, e.g., have to use a parameter to set a low number for the interrupt moderation and then use a different parameter to enable the interrupt moderation. Interrupt Moderation Rate) and turn this feature off (or set it to it's lowest value).įor your network adapter, the way of setting the number of CPU interrupts may differ. Selet the parameter which relates to the number of CPU interrupts (e.g. Receive Descriptors) and set it to its maximum value.ĭ. Selet the parameter which relates to the number of receive descriptors (e.g. If no Jumbo Frames parameter is present, select the parameter which relates to frame size and set its size to the maximum value, which typically is 1.5 kB (1500).Ĭ. Select the Jumbo Frames (or Jumbo Packets) parameter and set its size to the maximum value.ī.
Also, the ways of setting the parameters may differ, and some parameters may not be available.Ī. Note: Depending on the network adapter model, the parameter names of your network adapter may differ from the ones shown below. Select the following parameters in the Properties group and set their values in the Value group: In the Network Connections window, right click on the name of the connection for your network adapter, and select Properties from the drop down menu.Ī controller properties window will open.ģ. To optimize your network adapter you can do the following:ġ. If you found out that you are losing packets/ frames while running your GigE camera, you may try to optimize the configuration of your network adapter. (set Guru mode first), then -> Stream Parameters -> Statistics. Typically this is due to some hardware caches/buffers on a network switch/nic becoming temporarily overfilled due to the sudden burst of incoming network packets.Ī handy way to check for lost packets/frames is to observe the statistics for you camera in pylon viewer: You may also notice packets/frames being dropped when simultaneously grabbing images from multiple cameras (ie: a hardware trigger run to cameras in parallel). You may happen to find out that you are losing packets/ frames while running your Basler GigE camera. (Also related to error 0圎1000014 / 3774873620: The buffer was incompletely grabbed)
0 kommentar(er)
